高效液相色谱-电喷雾串联质谱法快速测定纺织品中苯氧羧酸类除草剂残留量

建立了纺织品中7种苯氧羧酸类除草剂的高效液相色谱-电喷雾串联质谱(LC-ESI-MS/MS)快速检测方法.样品经甲酸酸化的丙酮溶液超声提取两次,无需其它净化过程.液相色谱使用C18反相色谱柱,流动相为醋酸铵水溶液和甲醇,在梯度条件下分析.在选择反应检测(SRM)负离子模式下进行质谱信号采集,采用两对同位素离子对进行定性和定量分析.选取3种有代表性的纺织品进行方法检出限(LOD)、定量限(LOQ)、线性、回收率和精密度的验证.方法的LOQ为 0.9～2.4 μg/kg; 回收率为85%～106%; 相对标准偏差为2%～11%.本方法简便、有效、可靠、灵敏,能够满足国际生态纺织品标准(Oeko-Tex Standard 100)的限量要求,适用于纺织品中苯氧羧酸类除草剂的日常检测及确证.     

Effect of preparation variables on morphology and pure water permeation flux through asymmetric cellulose acetate membranes

In this study, cellulose acetate (CA) ultrafiltration (UF) membranes were prepared using the phase inversion method. Effects of CA and polyethylene glycol (PEG) concentrations in the casting solution and coagulation bath temperature (CBT) on morphology of the synthesized membranes were investigated. Based on L₉ orthogonal array of Taguchi experimental design 18 membranes were synthesized (with two replications) and pure water permeation flux through them were measured. It was found out that increasing PEG concentration in the casting solution and CBT, accelerate diffusional exchange rate of solvent 1-methyl-2-pyrrolidone (NMP) and nonsolvent (water) and consequently facilitate formation of macrovoids in the membrane structure. Increasing CA concentration, however, slows down the demixing process. This prevents instantaneous growth of nucleuses in the membrane structure. Hence, a large number of small nucleuses are created and distributed throughout the polymer film and denser membranes are synthesized. Rate of water flux through the synthesized membranes is directly dependent on the size and number of macrovoids in the membrane structure. Thus, maximum value of flux is obtained at the highest levels of PEG concentration and CBT (10 wt.% and 23 °C, respectively) and the lowest level of CA concentration (13.5 wt.%). Analysis of variance (ANOVA) showed that all parameters have significant effects on the response. However, CBT is the less influential factor than CA and PEG concentrations on the response (flux).     

用于农药残留检测的酶生物传感器

酶生物传感器在农药残留检测方面具有传统检测方法不可比拟的优势.本文介绍了胆碱酯酶和有机磷水解酶在生物传感器中的应用,重点介绍了用于有机磷等农药残留分析的酶生物传感器的种类和研究现状,讨论了几种酶固定化方法存在的优势和局限,指出了目前研究需解决的问题并展望了未来的发展方向.     

功能添加剂对锂离子电池的防过充电化学行为研究

研究了功能添加剂3-氯苯甲醚(3CA)和联苯(BP)联合使用在锂离子电池电解液中的防过充行为。通过采用微电极循环伏安法、动电位扫描分析、扫描电镜法和充放电法等手段研究表明：联苯和3-氯苯甲醚混合添加剂的聚合电位随3-氯苯甲醚含量的增加由4.7V前移至4.6V (vs. Li/Li+);电池在正常工作电压(2.75V~4.2V)下,添加剂不参与电池反应过程;当电压高于4.2V电池发生过充时,3-氯苯甲醚在电极表面首先发生氧化还原飞梭分流限压对电池进行过充保护;电压继续升高时,联苯在电极表面发生电聚合反应,生成的聚合膜表面光滑致密是电子的良导体能有效的阻止Li+的嵌入与脱出,并通过自放电使电池处于安全状态,防止电池过充发生爆炸。两种防过充机制共同作用,对电池实施多重护防,提高了电池的安全性能。     

Post-blast detection of traces of explosives by means of Fourier transform infrared spectroscopy

Samples obtained from debris after explosions of about 30 g of energetic materials were analyzed by means of Fourier transform infrared (FTIR) spectroscopy using both, Globar and synchrotron infrared radiation at the ISMI beamline of the Singapore synchrotron light source (SSLS). Low- and high-strength-of-explosion blasts were performed during each test run with the same explosive material. From the spectroscopic measurements, traces of unreacted explosives were found on more than 200 different materials that served as sample catchers in the explosions.The integrality of the experiments done confirmed that FTIR spectroscopy is a sufficiently sensitive method to detect traces of explosives in post-blast residues even of high-strength explosions. The method requires only a minimal amount of sample and enables accurate and very fast identification of the presence of explosive material. Finally, the synchrotron radiation infrared source provided one order of magnitude higher sensitivity compared to the conventional Globar source.     

气相色谱-电子轰击离子源质谱法分析卷烟和烟叶中29种农药的残留

开展了卷烟和烟叶中有机氯、有机磷和拟除虫菊酯3类29种农药残留的气相色谱-电子轰击离子源质谱(GC-EI/MS)的分析方法研究。优化与选择了卷烟和烟叶样品的前处理条件,样品经正己烷-丙酮(体积比为1∶1)混合提取剂超声提取、Florisil硅土和中性氧化铝双净化剂固相萃取柱净化、二氯甲烷-正己烷(体积比为95∶5)混合洗脱剂洗脱和浓缩后,以磷酸三苯酯(TPP)为内标物,采用GC-EI/MS的选择离子监测方式(SIM)进行定性和定量分析。当样品的加标水平为20,50,100 μg/kg时,加标回收率为70%～110%,相对标准偏差在2%～8%之间;除了甲氰菊酯、氯菊酯和溴氰菊酯的方法检出限(LOD)分别为1.85,1.74与2.54 μg/kg外,其余的26种农药的LOD均小于0.8 μg/kg;线性范围为5.0～500.0 μg/kg,相关系数都大于等于0.9994。此分析方法已成功地应用于卷烟和烟叶样品中3类29种痕量农药残留的分析     

固定效应部分线性可加面板数据模型的惩罚二次推断估计

具有较强解释力和灵活性的部分线性可加面板数据模型在各学科领域应用广泛.针对个体内存在相关结构的固定效应部分线性可加面板数据模型,本文在结合幂样条函数和最小二乘虚拟变量(LSDV)法的基础上,利用惩罚二次推断函数(PQIF)法对模型进行估计,在一定的正则条件下,证明了参数估计的渐近正态性和非参数估计的收敛性,Monte Carlo数值模拟显示所述估计方法具有良好的有限样本表现,同时,我们还将估计技术应用于实际数据分析中.     

Xylene as a New Polymerizable Additive for Overcharge Protection of Lithium Ion Batteries

The electrochemical properties and overcharge protection mechanism of xylene as a new polymerizable electrolyte additive for overcharge protection of lithium ion batteries were studied by cyclic voltammetry tests, charge- discharge performance and battery power capacity measurements. It was found that when the battery was overcharged, xylene could electrochemically polymerize at the overcharge potential of 4.3—4.7 V (vs. Li/Li＋) to form a thin polymer film on the surface of the cathode, thus preventing voltage runaway. On the other hand, the use of xylene as an overcharge protection electrolyte additive did not influence the normal performance of lithium ion batteries.     

磺丁基醚-β-环糊精手性流动相添加剂法分离兰索拉唑对映体

采用磺丁基醚-β-环糊精(SBE-β-CD)为手性流动相添加剂,建立了兰索拉唑对映体的高效液相色谱分离分析方法.对影响兰索拉唑对映体分离的主要因素:环糊精种类和浓度、缓冲溶液pH以及有机改性剂种类和含量进行考察.确定最优色谱条件:色谱柱为Spherigel C18 (150 mm×4.6 mm,5 μm),流动相为V(乙腈):V(水相)=20:80(水相含10 mmol/L SBE-β-CD、 10 mmol/L NaH2PO4缓冲液、 pH 2.5),流速为0.9 mL/min,检测波长为288 nm.在此条件下,兰索拉唑对映体的保留时间分别为14.4和15.8 min,分离度为2.0.两对映体质量浓度在0.2～50 μg/mL范围内线性关系良好(r≥0.9996),保留时间的RSD分别为0.27%和0.26%,峰面积的RSD分别为0.65%和0.68%.     

Continuation of multiple power series in a sectorial domain

For multiple power series centered at the origin we consider the problem of its analytic continuability into a sectorial domain. The condition for continuability is formulated in terms of a holomorphic function that interpolates the series coefficients. For series in one variable this problem has been studied in the works of E. Lindelöf, N. Arakelian, and others.